Loctite SF7387 Activator
Loctite SF 7387 Dihydropyridine Activator 52ml
- Viscosity : Very low
- Color : Amber, Translucent, Yellow
- Curing Type : Not applicable
- Application : Cure promotion of toughened
LOCTITE SF 7387 is a yellow to amber, transparent liquid substituted dihydropyridine activator containing the solvents n-Heptane and isopropanol. It is designed for LOCTITE toughened adhesives to initiate the cure of acrylic adhesives.
- Designed for LOCTITE adhesives
toughened acrylic adhesives.
Fixture time and cure speed achieved as a result of using
LOCTITE® SF 7387™ depend on the adhesive used, the
substrate bonded, surface cleanliness and whether one or two
surface activation is used.
Activator must be handled in a manner applicable to highly
flammable materials and in compliance with relevant local
The solvent can affect certain plastics or coatings. It is
recommended to check all surfaces for compatibility before
This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected
with a sealant for chlorine or other strong oxidizing
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Under no circumstances should activator and adhesive be
mixed directly as liquids. Use only in a well ventilated area.
Directions for use
- Most surfaces may be bonded "as received" but
contamination such as loose oxide layers or excessive oil
may affect cure speed and bond strength. Cleaning is
recommended if maximum strength is required.
- Brush on the activator to one of the mating surfaces to be
bonded. Apply adhesive to other surface.
- For large gaps (>0.4 mm) or where maximum cure speed
is required then treatment of both surfaces is
- Allow 1 to 5 minutes for solvent to evaporate. After the
solvent evaporates, the active ingredients will appear wet,
and will remain active for up to 2 hours after application.
Contamination of the surface before bonding should be
- Where adhesive is applied onto an activated surface,
assembly should be completed as quickly as possible
(within 15 seconds).
- Secure the assembly and await fixturing before any
Loctite Material Specification
LMS dated September-01, 1995. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.
This activator is classified as HIGHLY FLAMMABLE and
must be stored in an appropriate manner in compliance with
relevant regulations. Do not store near oxidising agents or
combustible materials. The product is light sensitve and
accordingly, translucent containers should be kept in a dark
place when not in use. Store product in the unopened
container in a dry location. Storage information may also be
indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
cannot assume responsibility for product which has been
contaminated or stored under conditions other than those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative
This product has no reviews yet.