Loctite SF7109 Accelerator

Loctite SF 7109 Accelerator 52ml

• Viscosity : Very low
• Color : Clear, Clear: Ultra Clear
• Curing Type : Not applicable
• CA adhesive cure accelerator

 

LOCTITE® SF 7109 is a perfluocarbon-based activator that increases the cure speed of LOCTITE instant adhesive. Non-flammable and non-combustible. Excellent for cosmetic applications, for clear and transparent adhesive beads or fillets. On-part life of 1 min.

• Non-flammable and non-combustible
• Excellent for cosmetic applications
• For clear and transparent adhesive beads or fillet

LOCTITE® SF 7109™ is used where increased cure speed of
LOCTITE®
cyanoacrylate adhesives is required. It can be
either pre- or post-applied to the bond. The product is
non-flammable.

Strength vs. Time

The graph below shows the shear strength developed with time
using LOCTITE® SF 7109™ with LOCTITE®
adhesive 416™.
Testing was performed @ 22 °C in accordance with ISO 4587.

Handling precautions

The solvent can affect certain plastics or coatings. It is
recommended to check all surfaces for compatibility before
use.

GENERAL INFORMATION

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected
with a sealant for chlorine or other strong oxidizing
materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Under no circumstances should activator and adhesive be
mixed directly as liquids. Use only in a well ventilated area.

Directions for use

Post Activation

1. Apply Loctite cyanoacrylate to the parts to be bonded or
   fixed.
2. Apply Activator over all exposed cyanoacrylate adhesive
   by spray or drop. (Typically use one drop of activator per
   drop of exposed adhesive).

Surface Activation

1. Apply one coating of Activator to the area to be bonded by
   spray, brush or dipping. Contaminated surfaces may need
   special cleaning or degreasing prior to activation to
   remove any soluble contamination.
2. Allow LOCTITE® SF 7109™ to fully evaporate from parts
   prior to bonding to avoid solvent entrapment within the
   bond joint.
3. Apply the Loctite cyanoacrylate product immediately after
   drying or not more than 45- seconds thereafter.
4. Activator can be re-applied if necessary if there is a delay
   of more than 45- seconds between original activator and
   adhesive application.
5. Due to physical solvency effects material may become
   cloudy which does not affect performance. To eliminate
   cloudiness heat material to 30C, then shake.

Loctite Material Specification

LMS dated September-25, 1996. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.

Storage

The product is light sensitive and accordingly, translucent
containers should be kept in a dark place when not in use.
Store product in the unopened container in a dry location.
Storage information may also be indicated on the product
container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
cannot assume responsibility for product which has been
contaminated or stored under conditions other than those
previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.