MAGNAFLUX SPOTCHECK- SKC-S Aerosol

0.0

Description

MAGNAFLUX SPOTCHECK- SKC-S Aerosol


SKC-S is an NDT-approved solvent cleaner/remover for pre-cleaning before non-destructive testing and for removing excess surface penetrant from an inspection area before applying developer during liquid penetrant testing.
This non-halogenated solvent remover can be used on a wide range of substrates to remove oils, greases and other contaminants. SKC-S dries quickly without leaving a residue, and meets the low-residue requirements for NDT and aerospace penetrant testing.

Benefits:


Maximize range of inspections

  • Inspect a wide range of components without worry
  • Conforms to AMS 2644 Class 2, ASME BPVC and all major aerospace requirements
Application versatility

  • Use a single cleaner throughout the entire penetrant testing process
  • Comes in both bulk and aerosol forms, or as part of a kit for convenience
Minimize risk of missing a flaw

  • Inspect reliably by cleaning only the surface without flushing penetrant out of discontinuities
  • Dries quickly without leaving residue to prevent false indications
 

Features:



  • AMS 2644 Class 2 nonhalogenated remover
  • Fast drying
  • Leaves no residue
  • Suitable for use at low temperatures
  • Alloy compatibility
  • Bulk or aerosol form
  • Doesn’t over clean

Application:


Ideal for:
  • Non-destructive testing pre-cleaning
  • Removing excess surface penetrant
  • Post inspection cleaning
  • When chlorinated solvents are undesirable or
    prohibited

SPECIFICATION COMPLIANCE



  • AECL
  • AMS 2644
  • ASME BPVC
  • ASTM E1417
  • ASTM E165
  • Boeing BAC 5423 PSD 6-46 or 8-4
  • Boeing PS-21202
  • General Electric P50YP107
  • ISO 3452-2
  • MIL-STD-2132
  • MIL-STD-271
  • NAVSEA 250-1500-1-REV-1
  • Pratt & Whitney PMC 4366
INSTRUCTIONS FOR USE

For NDT pre-cleaning:

  1. Spray the surfaces to be cleaned liberally with
    the cleaner then either wipe off or allow to air dry,
    or soak a clean cloth with the cleaner and wipe
    the part clean.
  2. Allow the part to dry thoroughly before applying
    the penetrant.

To remove excess surface penetrant:

  1. Apply SKC-S to a cloth, wipe test surface and
    repeat as needed.
  2. Do not spray SKC-S directly on the part
    because penetrant indications may be removed.

HEALTH AND SAFETY

Review all relevant health and safety information
before using this product. For complete health and
safety information, refer to the product Safety Data
Sheet, which is available at www.magnaflux.com.
 
Read More Read Less
Products

Categories

Magnaflux

Products Brand

You may also like