Loctite SF7109 Accelerator
Loctite SF 7109 Accelerator 52ml
- Viscosity : Very low
- Color : Clear, Clear: Ultra Clear
- Curing Type : Not applicable
- CA adhesive cure accelerator
LOCTITE® SF 7109 is a perfluocarbon-based activator that increases the cure speed of LOCTITE instant adhesive. Non-flammable and non-combustible. Excellent for cosmetic applications, for clear and transparent adhesive beads or fillets. On-part life of 1 min.
- Non-flammable and non-combustible
- Excellent for cosmetic applications
- For clear and transparent adhesive beads or fillet
cyanoacrylate adhesives is required. It can be
either pre- or post-applied to the bond. The product is
Strength vs. Time
The graph below shows the shear strength developed with time
using LOCTITE® SF 7109™ with LOCTITE®
Testing was performed @ 22 °C in accordance with ISO 4587.
The solvent can affect certain plastics or coatings. It is
recommended to check all surfaces for compatibility before
This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected
with a sealant for chlorine or other strong oxidizing
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Under no circumstances should activator and adhesive be
mixed directly as liquids. Use only in a well ventilated area.
Directions for use
- Apply Loctite cyanoacrylate to the parts to be bonded or
- Apply Activator over all exposed cyanoacrylate adhesive
by spray or drop. (Typically use one drop of activator per
drop of exposed adhesive).
- Apply one coating of Activator to the area to be bonded by
spray, brush or dipping. Contaminated surfaces may need
special cleaning or degreasing prior to activation to
remove any soluble contamination.
- Allow LOCTITE® SF 7109™ to fully evaporate from parts
prior to bonding to avoid solvent entrapment within the
- Apply the Loctite cyanoacrylate product immediately after
drying or not more than 45- seconds thereafter.
- Activator can be re-applied if necessary if there is a delay
of more than 45- seconds between original activator and
- Due to physical solvency effects material may become
cloudy which does not affect performance. To eliminate
cloudiness heat material to 30C, then shake.
Loctite Material Specification
LMS dated September-25, 1996. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.
The product is light sensitive and accordingly, translucent
containers should be kept in a dark place when not in use.
Store product in the unopened container in a dry location.
Storage information may also be indicated on the product
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
cannot assume responsibility for product which has been
contaminated or stored under conditions other than those
previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.
This product has no reviews yet.