Permatex® Muffler & Tailpipe Sealer

Permatex^® Muffler & Tailpipe Sealer

Permatex Muffler & Tailpipe Sealer is a specially formulated, thick, non-slumping paste type repair material. Seals holes and leaks in mufflers, tailpipes and around joints. Makes new installations more secure. Resists temperatures to 2000°F (1000?C).

PRODUCT BENEFITS

• Waterproof
• Non-shrinking
• Spreads easily
• Resists temperatures to 2000F

TYPICAL APPLICATIONS

• Mufflers
• Tailpipes
• Catalytic converters

DIRECTIONS FOR USE

1. Surfaces to be repaired should be free of dirt, grease, oil and rust.
2. Wet the surface to be repaired with water.
3. Apply the sealer directly over the hole.
4. Allow to dry for 30 minutes, then start engine and allow to run for 10 more minutes.
5. For new installations, apply sealer ¼ inch thick around inside of larger pipe. Complete and seal the connection.

For Cleanup

1. Clean up with water prior to the material drying.
2. Clean hands with a Permatex Fast Orange hand cleaner or soap and water.

TYPICAL CURING PERFORMANCE

Permatex Muffler & Tailpipe Sealer cures by the evaporation of water and further cures with heat. Full cure will be affected after 24 hours of drying and driving at the maximum operating temperature.

Chemical / Solvent Resistance

The fully cured product retains effective properties when in contact with water.

GENERAL INFORMATION

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Material Safety Data Sheet, (MSDS).
TDS
 

STORAGE

Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 to 28C (46 to 82F) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused product, do not return any material to its original container.
 

For More PERMATEX products