Loctite SF7061 Multi Purpose Cleaning Spray
Loctite SF 7061 Aerosol Multi Purpose Cleaning Spray 400ml
- Colour : Transparent
- Curing Type : Not applicable
- Application : Surface preparation
LOCTITE SF 7061 is a non-CFC solvent-based formulation for cleaning and degreasing surfaces to be bonded with LOCTITE® adhesives. The product is used as a final pre-assembly cleaning treatment to remove most greases, oils, lubrication fluids, metal cuttings and fines from surfaces to be bonded. Its high solvent power allows it to be very effective in other degreasing or part-cleaning applications.
- Solvent-based (acetone) general parts cleaner
- Very fast evaporation
- Removes dirt, resins, lacquer, oils and greases
for cleaning and degreasing of surfaces to be bonded with
adhesives. The product is used as a final
pre-assembly cleaning treatment to remove most greases, oils,
lubrication fluids, metal cuttings and fines from surfaces to be
bonded. Its high solvent power allows it to be very effective in
other degreasing or part-cleaning applications.
LOCTITE® SF 7061™ has no effect on the speed of cure or
final strength of LOCTITE®
adhesives other than providing a
clean surface for good adhesion and adhesive cure. Unclean
or partially cleaned surfaces can affect adhesive
This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Cleaner must be handled in a manner applicable to highly
flammable materials and in compliance with relevant local
regulations. Special care must be taken to avoid contact of the
product or its vapour with naked flame or any electrical
equipment that is not flame proofed.
The solvent can affect certain plastics or coatings. It is
recommended to check all surfaces for compatibility before
Directions for use:
- Treat surfaces to be bonded by generously spraying with
LOCTITE® SF 7061™.
- Wipe surfaces when still wet with a clean cloth to remove
all heavy contamination. If necessary, spray surfaces
again to allow run-off of product.
- Spray surfaces again, preferably with surfaces in vertical
position to allow run-off of the cleaner.
- Allow LOCTITE® SF 7061™ to fully evaporate from parts
prior to bonding to avoid solvent entrapment within the
- Apply the Loctite®
adhesive immediately after drying and
Loctite Material Specification
LMS dated September-01, 1995. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality
Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.
This product has no reviews yet.