Loctite SF768 Solvent (Adhesive Remover)



Loctite SF 768 Clean up Solvent X-nms for Instant Adhesive Cleaner 52ml

  • Viscosity : Very low
  • Color : Clear, Yellow: Light Yellow
  • Curing Type : Not applicable
  • Application : Removal of cured cyanoacrylate
    adhesive / surface cleaning

LOCTITE® SF 768 is a clear to yellow, solvent blend designed to remove cured cyanoacrylate adhesive from surfaces or to debond parts assembled with cyanoacrylate adhesive.

  • Removes cured cyanoacrylate adhesive from surfaces
  • Unbonds parts assembled with cyanoacrylate adhesive
SF 768™ is a solvent blend designed to remove
cured cyanoacrylate adhesive from surfaces or to debond parts
assembled with cyanoacrylate adhesive.

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Where aqueous washing systems are used to clean the
surfaces before bonding, it is important to check for
compatibility of the washing solution with the adhesive. In
some cases these aqueous washes can affect the cure and
performance of the adhesive.
This product is not normally recommended for use on plastics
(particularly thermoplastic materials where stress cracking of
the plastic could result). Users are recommended to confirm
compatibility of the product with such substrates.
Handling precautions

The solvent can affect certain plastics or coatings. It is
recommended to check all surfaces for compatibility before
Directions for use

  1. Applying LOCTITE®
    SF 768™ to cured cyanoacrylate
    adhesive will allow its removal in several minutes to
    several hours, depending on the amount of the adhesive.
  2. Thin layers of adhesive will wipe off with a LOCTITE®
    768™ soaked tissue or cloth.
  3. Thick beads or drops will take between 15 and 30 minutes
    and will require reapplication of solvent.
  4. Bonded parts may require several hours of soaking

Loctite Material Specification

LMS dated September-28, 2009. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.

Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.
Read More Read Less
Productsနှင့် Cleaner / Remover



Products Brand

You may also like