Loctite Ea9340 Epoxy Adhesive Grey 75.9g



Loctite Ea9340 Epoxy Adhesive Grey 75.9g

  • Key Substrates : Ceramic, Metal, Plastic, Wood
  • Color : Grey

LOCTITE® EA 9340 is a gray, 2-part, epoxy, general purpose adhesive paste with exceptional high-temperature performance and chemical resistance. Full cure is achieved in 24 hr at room temperature, although heat can be used to achieve a quicker cure. The product can bond wood, metal, ceramic, and most plastics, and can be sanded, drilled, and painted after curing.

  • Excellent heat resistance
  • Good tensile shear strength
  • Resistant to automotive fluids
  • Can be sanded, drilled, and painted
  • Easy to mix
  • Bonds wood, metal, ceramic, and most plastics
LOCTITE® EA 9340 is a general purpose adhesive with exceptional
high temperature performance. This easy to use epoxy is can be
used in many demanding applications where resistance to chemicals
and heat extremes are required. LOCTITE® EA 9340 can be used
on many different substrates such as wood, metal, ceramics, and
most plastics. This exceptional epoxy can be sanded and drilled and
painted after curing making it ideal for finish work.

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).

Mixing: LOCTITE® EA 9340 requires mixing Part A and Part B
together just prior to the application. Complete mixing of the two
components is necessary.

Mixing: Combine Part A (resin) and Part B (hardener) in the correct
ratio and mix thoroughly. Continue to mix until all green and gray
streaks are gone and mix is uniformly gray. This is important! Heat
build-up during or after mixing is normal. Do not mix quantities
greater than one pound as excessive exotherm or heat build-up will
develop. Mixing smaller quantities will minimize the heat build-up.

Application: Bonding surfaces should be clean and dry. The bonded
parts should be held in contact until the adhesive is set. It not
necessary to maintain fixturing for the entire cure schedule but only
until handling strength is achieved.

Cure: LOCTITE® EA 9340 can be cured by a variety of cure
schedules to meet processing requirements. LOCTITE® EA 9340 will
achieve handling strength in 6-8 hours at room temperature (note:
this can vary with different bond configurations and ambient
temperatures). Full cure time at 77oF is 24 hours. Heat cures can be
used to shorten this time. For instance, one hour at 180oF or 2 hours
at 140oF is sufficient to fully cure the adhesive.

Clean up: It is important to remove excess adhesive from the work
area and application equipment before it hardens. Many common
solvents and citrus cleaners are suitable for removing uncured
adhesive. Consult with your solvent supplier for information
pertaining to the safe and proper use of solvents.


Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.

Read More Read Less
Productsနှင့် Adhesive / Sealant



Products Brand

You may also like